Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Sunland
If your chimney cap is rusted, loose, or gone, or the mortar crown on top of your stack is cracked and spalling, water is getting into the masonry every winter whether you notice it or not. We install, replace, repair, and coat caps and crowns for homeowners across Sunland, from the flat streets near Foothill Blvd up into the canyon-adjacent properties at the base of the Verdugo Mountains. Cap and crown work is one of our five core service lines, not a side job, and we know what pre-1960s Sunland chimneys tend to look like under the mortar. Call (855) 710-2744 and we’ll book an estimate.

Why Sunland Homeowners Call Chimney Sweep Sun Valley for Chimney Cap & Crown
Caps and crowns are the two spots where most water intrusion starts, and on older Sunland chimneys they’re also the spots most likely to be sold as something bigger than they are. We don’t work that way. Nothing gets recommended to you without camera evidence you can watch on a screen and point at, and if a repair can safely wait a season, we say so.
We work with the professional-trade materials chimney specialists specify: HeatShield ceramic resurfacing for damaged flue interiors, DuraFlex flexible liners when a flue truly needs relining, and caps from Gelco and Olympia Chimney. These are the lines a chimney trade shop carries, not what’s on the shelf at a hardware store. Our technicians have up to 13 years of experience, and we cover the whole system from firebox to crown, so you’re not bouncing between a mason and a sweep. For Sunland homeowners, that matters: the same person who inspects your flue can set the cap and rebuild the crown instead of handing you off.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Sunland
Cap Installation
A properly sized cap keeps wind-driven rain, animals, and embers out of the flue while still letting smoke escape. On Sunland homes near the canyon edges, we pay close attention to spark arrestor screening, because embers off the Verdugo foothills during a red-flag warning are a real concern here, not a talking point. Our chimney cap & crown work starts with measuring the actual flue opening so the cap fits the stack rather than sitting loose on top of it.
Cap Replacement
Most replacement calls we get in Sunland are for the same thing: a single-flue cap that rusted through or a wrong-fit unit that never sealed properly over a multi-flue stack. A cap that’s cocked sideways or has a torn screen does two jobs badly, letting water in and letting animals and embers past. We pull the old unit, check the flue tile edges and crown beneath it for damage the failed cap may have caused, and set a correctly sized replacement.
Crown Repair
The crown is the concrete or mortar slab on top of the chimney that sheds water away from the masonry. On 1940s-1960s ranch homes along Foothill Blvd and into the canyons, we often find original single-wythe brick crowns cracked and spalled after decades of wind-driven rain and seasonal movement. Left alone, that crack lets water straight into the brick and rusts the damper below. Crown repair rebuilds the overhang and slope so water runs off the way it’s supposed to.
Crown Coating
When a crown is sound underneath but the surface has cracked and gone porous, a coating can seal it without a full rebuild. Coating is the cost-conscious path when the structure allows it, and we say plainly when a crown is too far gone for it. Across Sunland, crown coating is often paired with cap replacement, since both problems usually show up together.
Trusted Brands We Service in Sunland
We specify and install DuraFlex flexible liner systems, the professional standard for relining older or offset flues, and we use HeatShield ceramic resurfacing to restore a deteriorated liner where the structure allows it instead of jumping straight to a full relining. Caps come from Gelco and Famco, with components sourced through Copperfield and Olympia Chimney, two of the most recognized professional chimney supply distributors in the trade. We don’t claim to carry parts on a truck or keep a warehouse of stock; what we do is specify the right component for your stack and install it correctly. That keeps turnaround reasonable and the work right.
Common Chimney Cap & Crown Problems We See in Sunland Homes
- Cracked and spalled original crowns. Single-wythe brick crowns from the 1940s through the 1960s have typically taken decades of wind-driven rain and seasonal movement, and many are now cracked enough to let water down the flue. Many also sit on canyon-edge chimneys built before modern seismic bracing, so a leaning or cracked crown here is often a movement and wind issue as much as ordinary wear.
- No cap, or a rusted-through one. A missing or failed cap lets water run straight down the flue and rust the damper, and it lets animals in. On older Sunland stacks the cap is frequently the original single-flue unit, long past useful life.
- Wrong-fit caps on multi-flue stacks. Oversized or poorly fitted caps over a multi-flue chimney let embers and animals past a loose screen, which defeats the whole point of a spark arrestor before red-flag season. A cap has to match the stack, not just cover it.
- Unlined or deteriorating clay-tile flues venting appliances they were never designed for. This is where the industry’s worst upselling happens. A pitch for full relining often starts before any Level 2 camera documentation is shown, and we won’t do that.
Why Sunland’s canyon-edge chimneys need a closer look than most
Sunland’s canyon-edge masonry chimneys were often built before modern seismic bracing, so a cracked or leaning crown here is frequently a seismic-movement and Santa Ana-wind issue as much as freeze-thaw wear. Wind-driven rain off the Verdugo foothills works water into those same cracks every winter, and the hot, dry wind season that follows puts the whole stack under stress in a very high fire hazard severity zone. That cycle is why we treat a crown inspection as structural, not cosmetic. Here’s how a typical job usually goes: a homeowner has an original clay-tile flue under a decades-old mortar crown that has cracked and spalled, letting winter rain seep into the masonry and rust the damper, while the cap, often missing or a loose single-flue unit, lets embers and animals in before red-flag warnings. A qualified pro runs a camera through the flue, shows the cracked crown, spalling brick, and any glazed third-degree creosote on a screen, then rebuilds or coats the crown, sets a correctly sized multi-flue or custom cap with proper clearance, and re-checks draft at the firebox. HeatShield or Gelco is commonly specified when an unlined or damaged clay flue needs restoring to a safe condition. That camera evidence comes before any recommendation, every time.

See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Sunland, CA
Cap and crown work is quoted per job, and the written estimate sets the final price. Typical ranges for Sunland:
| Service | Typical Sunland Range |
|---|---|
| Standard cap installation or replacement | $250 – $550 |
| Custom or multi-flue cap | $450 – $900 |
| Crown repair (rebuild) | $550 – $1,200 |
| Crown coating | $350 – $700 |
| Camera inspection (Level 2) | $200 – $400 |
What moves the number: stack height, how many flues need covering, whether the crown needs a full rebuild or just a coating, and access on canyon-adjacent properties where the roofline is steeper. Inspection is often bundled with the repair estimate. Estimates are free.
We Also Serve Cities Near Sunland
Sunland sits alongside Tujunga and La Crescenta-Montrose in the foothills, and we also cover Sun Valley and Burbank. The housing stock and wind exposure are similar across these areas, so what we find on a Sunland stack is usually what a neighbor one block over is dealing with too. If you’re Sunland-based but not sure whether your address falls in our area, call and we’ll confirm.
Serving Sunland, CA – Our Local Coverage Area
We serve Sunland and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Sunland
Because Sunland’s fire hazard severity and its winter rain exposure both stress the chimney, and the timing catches different problems. Before fire season, an inspection catches glazed creosote and a failed cap screen that could let embers escape; after the winter rains, it catches cracked flue tiles and water that has gotten into the masonry. The Santa Ana wind season off the Verdugo foothills is the reason many homeowners here schedule a sweep and spark-arrestor check in the fall. Call (855) 710-2744 for an exact quote on an inspection.
You know by camera evidence, not by a sales pitch. First-degree creosote is soot that brushes off easily; glazed third-degree creosote is a hard tar layer that a standard sweep won’t remove, and it’s the kind that raises fire risk. We run a camera through the flue and show you the footage so you can see it yourself. If a sweep is all it needs, that’s all we quote. Call (855) 710-2744 for an exact quote.
Annual inspection is the common industry standard, and it’s smart practice regardless of how much you burn, but it’s your call. Even a lightly used fireplace can develop a cracked crown, a failed cap, or a flue tile that’s shifted, especially on older Sunland homes in a high-wind zone. A camera inspection catches those early. Call (855) 710-2744 to book an inspection and get a clear picture.
We dispatch crews Sunday through Friday, 7am to 7pm, and Sunland jobs are usually booked quickly. Same-day is often possible depending on the schedule. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (855) 710-2744.
Not for us. Our pricing is set per job by the written estimate, and Sunland isn’t priced differently from Tujunga or La Crescenta-Montrose for the same work. What changes the number is the stack itself: height, flue count, crown condition, and access. Call (855) 710-2744 for an exact quote on your chimney.
Book Your Sunland Cap or Crown Estimate
If your cap is missing, rusted, or sitting wrong over a multi-flue stack, or the crown has cracked and is letting water in, call us and we’ll take a look. We’ll run a camera through the flue, show you what we find, and tell you plainly whether the work can wait or needs doing this season. Call (855) 710-2744 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Sun Valley.